Durax Teak Oil

Oil penetrates deep into the timber: it nourishes and protects from within, brings out the grain, and can be repaired locally without stripping.

Wax protects at the surface and gives richness, depth and a soft lustre - light protection, to be renewed regularly.

Polishes restore an existing finish, from everyday furniture products through to traditional French polish.

Varnish forms a protective film on the surface with excellent resistance to moisture, stains and everyday wear: the choice for hard-working surfaces.

Both form a protective film, but they behave differently. Varnish builds a thicker, tougher coating that resists moisture and knocks: doors, worktops, heavily used furniture.

Lacquer lays down a thinner, fast-drying film that builds through successive coats into a smooth, refined finish. It excels on wooden floors, but suits doors, furniture and joinery too.

It depends on the look you want and the maintenance you will accept:

• Hard wax oil - penetrates the timber, durable protection, natural low-sheen look, local repairs possible.
• Floor lacquer - a clear water-based film for residential floors; the reinforced version suits commercial settings.
• Traditional wax polish - the finest patina, but regular upkeep and limited water resistance.

Hard wax oil is our first choice: it penetrates the timber and protects against water, stains and daily use while keeping the grain alive. Allow three to four thin coats, after staining if you are staining.

If you prefer a more closed, tougher film, a quick-dry kitchen and bathroom varnish does the job very well. Either way, treat the edges and the underside of the worktop to stop moisture creeping in.

Yes - that is where they come from. Our oils, lacquers and varnishes are formulated for floors, joinery and fitted furniture, including commercial environments in the reinforced versions. Technical sheets are on the Product advice sheets page, and the trade area gives access to trade pricing.

Vacuum or sweep regularly, and mop with a well-wrung cloth and a neutral product - never an aggressive detergent or a steam cleaner, both of which strip the film. A maintenance coat over the traffic areas, roughly once a year, keeps the protection up without going back to bare timber.

Dust it, then work a maintenance polish or wax in with a soft cloth, in small amounts, following the grain. Leave it a few minutes, then buff. If the wax is dirty rather than dull, a light de-waxing before re-waxing will give far more back.

Entirely down to use. An oiled worktop wants attention every six to twelve months; an oiled floor, an annual maintenance coat over the traffic areas; a waxed piece of furniture, buffing two or three times a year. Varnished and lacquered surfaces last for years, then are redone in full when the time comes.

Close them tightly, away from frost, heat and direct sun. Take care with oil-soaked rags: as they dry they can heat up spontaneously and catch fire. Spread them out flat to dry completely in the open air, or soak them in water before disposing of them.